满粘法是将pvc卷材全部粘结在基层上的施工方法Full bonding method is the construction method of PVC coiled material on the base.
一、施工时，首先要进行预铺，把PVC卷材自然平铺于放线的基层表面(先不粘结)，要求平整顺直，不得扭曲During the construction, we must first pre shop, the surface of PVC membrane natural tile to put the line (the first bond), request smooth straight, not twisted.
二、卷材纵向搭接宽度50mm，并进行适当的剪裁。横向采用对接处理，其上用200～250mm宽的无复合层(N类)．PVC卷材覆盖搭接施Coil longitudinal lap width 50mm, and appropriate tailoring. The transverse butt welding is adopted, which is covered with 200 to 250mm wide.PVC layer without composite layer (N).
三、将一幅或多幅卷材的长边折叠一半(约10m)，从折叠处分别在基层和卷材表面涂刷专用胶粘剂，待胶干燥至不粘手时，将预铺卷材面进行合拢粘贴用压辊压实。然后再把另外没有折叠的部分折叠起来，继续从折叠处如前所述操作，依次类推粘贴牢固压实。最后进行对接缝焊接施工The long one or more than one coil folded in half (about 10m), from the fold respectively in the base and membrane surface coating adhesive to glue to dry, not sticky, the laying surface coil closure paste with roller compaction. Then, the other folded part is folded up, and then, from the folding place, as before, the operation is carried out. Finally, the seam welding construction.